Installation Instructions
for ‘09 d’lite, Encore and Solo
(Euro) Child Trailers
Installation Instructions
for ‘09 d’lite, Encore and Solo
(Euro) Child Trailers
®
®
™
™
™
™
Contents:
Contents:
(1) Burley Owner’s Instruction and Safety Manual
(1) Hitch
(1) Burley Owner’s Instruction and Safety Manual
(1) Hitch
(1) Clear light with batteries included
(1) Red light with batteries included
(2) Phillip Pan screws
(1) Clear light with batteries included
(1) Red light with batteries included
(2) Phillip Pan screws
(2) Brackets for lights
(2) Brackets for lights
(1) Wheel guard assembly:
(2) wheel guards
(1) Wheel guard assembly:
(2) wheel guards
(4) screws
(4) screws
(1) 5mm hex key wrench
(1) 5mm hex key wrench
Tools Required:Phillips screwdriver
4mm hex wrench
Tools Required:Phillips screwdriver
4mm hex wrench
10mm or open end wrench
10mm or open end wrench
Note: Consult your Burley Owner’s
Instruction and Safety Manual for
wheel guard and hitch installation
instructions.
Note: Consult your Burley Owner’s
Instruction and Safety Manual for
wheel guard and hitch installation
instructions.
Roll Bar Installation
1. If handle bar receivers are already
installed, loosen and remove handle bar
Roll Bar Installation
1. If handle bar receivers are already
installed, loosen and remove handle bar
rear Assembly
rear Assembly
Frame
Frame
Lock Nuts
Lock Nuts
knobs and outer handle bar receivers.
Figure 1
knobs and outer handle bar receivers.
Figure 1
Screws
Screws
Handle bar
Knob
Handle bar
Knob
2. Using wrench, loosen and remove
lock nuts and screws from handle bar
receivers.
2. Using wrench, loosen and remove
lock nuts and screws from handle bar
receivers.
3. From trailer front, slide roll bar into upper
handle bar receivers, with curved front
extending above trailer body.
3. From trailer front, slide roll bar into upper
handle bar receivers, with curved front
extending above trailer body.
inner Handle bar
receiver
inner Handle bar
receiver
4. Match holes in roll bar and inner handle
bar receivers, re-install screws and
4. Match holes in roll bar and inner handle
bar receivers, re-install screws and
tighten lock nuts.
tighten lock nuts.
roll Bar
roll Bar
Outer Handle bar
receiver
Outer Handle bar
receiver
5. Replace outer handle bar receivers and
5. Replace outer handle bar receivers and
tighten knobs.
tighten knobs.
Figure 1: Roll Bar Installation
Figure 1: Roll Bar Installation
|
Alpine CDA 7944R User Manual
Ariston 28 MFFI User Manual
Audiovox MP6211 User Manual
Belkin BLUETOOTH HOT SYNC OPERATION T665C User Manual
Blaupunkt LIMA CR 47 User Manual
Bosch Appliances Boiler 24i junior User Manual
Clarion OHM733 User Manual
Denon ADV 1000 User Manual
Fusion Electronics Car Speaker MR FR6520 User Manual
Grindmaster 3311 User Manual